Well, well, well... I’ve since purchased quite a few things to put murderzilla back together.

My Makita drill batteries seem to have died and purchased a 300cca lithium WPS battery to take their place.

Ahhhh. Did some modifications on the thumb throttle to accept a microswitch.

Purchased a Leash single stage relay board and progressive controller for the nitrous.

Purchased some 18x2 spindle mount front wheels and painted flat black, along with some 81” roll out 16 paddle straight extremes. Painted flat black.

Purchased a lightweight plastic wheelie bar wheel with a titanium shaft.

Removed the aluminum tank from the nose and will be replacing it with a 1.5qt poly tank between the upper frame rails above the engine.

Purchased a CF seat pan and sold the trimmed down banshee one I had.

All in all, may have dropped 8-10# so far. Maybe not.

With it being below freezing and negative digits with wind chill in a shop with a ventless heater. Not much more is happening.

Put in for time off for the PSDA races in Louisiana in May and time off for PSDA race in Kentucky in October. Just see how deep in the 3’s this thing can go.