Can't get my bike figured out why it will not kick start but will pull start. Used to be able to pull start it then it would kick start once warm, now it won't kick start warm or cold. I've replaced dry side crank seal and regrounded and cleaned all connections. There is a hard spot in the kick from doing the starting procedure just past first hard spot then bring kicker back up and hammer it, that first hard spot stops my foot like a concrete floor. So I'm pulling my motor and tearing it apart. I recently did rings and gaskets about 6 rides before this all started. The bike started up fine and ran great before I did my swing arm swap. The swing arm swap is when this all started and I didn't do a damn thing to the motor. So that's what I've done to my 500 this week. But it's been sitting because of this issue since last July which is very sad.