ZF

Nice rendering on the bowl.  Just a few questions.

Are these setup to only run on PWK carbs? - Currently these will only bolt up to a PWK carb and some PJ carbs to my knowledge. I don't have a TM carb to check bolt pattern and fitment. If I could find a TM carb, I could design up an adapter plate that matches the bowl to the TM carb.

What is the function for the top nipple?  Sorry I'm a bit slow. Top nipple is the overflow fitting.

Have you thought of making it out of one piece instead of using an adapter plate? I have thought about this, but really can't. Many reasons, one being access to the 4 bolts to tighten them down between the carb and plate. Second is machining, will be hard to machine the bowl to size when you have a small limited access. If casting/injection molded, this could work, but not for machining.

Just wondering...

Keep generating ideas.

LT