what the hey my phone keeps wacking out
Better than wacking off. Now where's the vid.
Where is the video?I ain,t seeing it?
ended up geting 2nd out of 6 250rs, beat some esr cylinder bikes, 1rst place was a d&d built 250r that was set up for drag with plus6 swinger aluminum drag axle the hole9 yards
Nice run! Get him some likes!
Wish I could get my 250 to run like yours. Im so sick of it I bought trx250r.
Whoa whoa slow down buddy. You just saw a Suzuki beat a more modified trx250r
how do you know it had a 4mil engine
good race none the less
Owner said it was, otherwise i wouldnt no, didnt have spacer set up
Shank Jr. The trx I just bought spank my lt ass. Not a fair fight.
i was just messing around with ya
Owner said it was, otherwise i wouldnt no, didnt have spacer set up
probably a stock crank hahaha
Some ppl build them with out spacer and machine cylinder head 2mm plus or minus to sett squish clearance. I think most ppl prefer that route, but idk really not much of a hondabater
Went back to this track today to play around with buddys, i had my dynoport pipe on with 14-39 gears, i ran 3tenths faster then i did at this previous race and was more consistant, i may have a shot at winning next race
What gear you launch at with that gearing?Whta size tires?Just curious.Sounds like you have that 250 screaming really well.
I launch in 1rst with this gearing with 21in 8paddle sand snakes, 2nd is alittle to much, id like to try 13 on front for 2nd gear launch to see if its any better.
What size wheel and how long of a race
Alot of the cylinder setup have to have .250 spacer plate. 363 sphinix is setup not to run spacer. Even if its a long rod motor they have to have .190 plate to run 86 piston. Im running spacer on my 4mil esr 310 pv. I just seen a 4 mil 310 put down very close to 58hp and 37 torque on pump gas a couple days ago.
I was talkin about stock cylinder 4mill,
Pc its 300ft, i run 20inch tires on 8inch wheel, there 8paddle sand snakes. Just cheapies
