I will keep this thread updated as I work through the re-assembly.  I just spent some time with the wire wheel on the bench grinder as all the engine mount bolts and the swingarm bolt were quite corroded and devoid of the grease that should have been on them.  They are all cleaned up and I am just about to dig in on getting the motor back in the bike.  I plan to try and get the motor back in and snugged up, the carb mounted, and connect the final wiring from the stator to the rest of the wiring system tonight.  We will see if I get further than that but realistically the chain, the exhaust, gas tank, plastics, and the rest will have to wait until tomorrow morning.  My main goal is to have it totally back together while there is still sunlight so I can start it up and take it for a test ride.  There is a few inches of snow left on the ground but I took those Duro flat track tires off of the back and put the Razrs on so I should have enough grip to tear through the snow tomorrow.  We actually may get some more snow tonight but if the snow is too deep I will just take the snowmobile out and do a few laps around some of the fields to pack down a track to ride the quad on.