my lt hub is stuck other side came off with a few taps and the barring was good and still had grease in it this one the outer barring is beat it has a wobble to it but wont budge... any suggestions?
penetrating lube if that don't work you will have to heat her up or use a puller. , Then Replace all the bearingz
have the barrings to replace it is just getting it off lol =) thanks i will try some wd tomrro just finished my oil seals today and polished the head up for a more chrome look
A mechanic once told me, when in doubt, be more violent. Lol
that is what i used to do... but now i try and take it easy i dont want to replace more things then i have too =) already 500$ in to this 85
Some type of penetrating oil and a big hammer. A torch could also be useful.
Use PB blaster not WD40, WD40 is a lubricant, PB blaster is penetrating oil. Soak it good with PB let it sit a while keeping it wet. A good hit from a hammer should loosen it. Use a piece of 2x4 to pound on, don't hit the hub with the hammer directly.
Try a 2-3 pound slide hammer with a spanner attachment. Bolt the spanner to the wheel studs, soak her down with Blaster, then slide hammer that biotch.
BFH lol funny stuff ya i am getting some PB this weekend .. tight budget =( just finished the port job and motor frame swing arm carrier rebuild and lots of paint =) ... my budget for this is about -10 lol will try the PB and 2x4 this week
btw i got it off a while ago let it sit in pb for about 2 days then heated it up with propain torch and hit it with a rubber mallet and pop it jumped right off
Nice to see you got it off!