Throttle cable doesnt seem long enough.

• Throttle cable doesnt seem long enough.
  Posted by LT250RWV on 30 Jan, 2014 22:34
• I just put a new mikuni tm 38mm on my 91 lt250. When I put the cable in the slide it was tight. Twisted all the slack out of thumb throttle. Help a little.  Still to tight causing slide to lift. Got it down enough to control slide height. Put not enough slack in the cable. Anyone else have this problem. Should I order a zilla throttle cable. Would zilla cable fix this.
• 
  
• #1 Reply
  Posted by Nekrofilliak on 31 Jan, 2014 06:33
• if I remember I had to remove the cable adjuster nut  on the thumb side , and adjust the free play on the carburator. maby that should help  ?
• 
  
• #2 Reply
  Posted by LT500Kid on 31 Jan, 2014 06:54
• Check the way you routed the cable too. Sometimes that's makes a difference
• 
  
• #3 Reply
  Posted by Iceracer on 31 Jan, 2014 07:13
• Use your cable from the 39pwk, a zilla cable will be too short also without the OEM 500 Carb cap it is recessed and don't have the adjuster on the top.
• 
  
• #4 Reply
  Posted by Roach on 31 Jan, 2014 07:22
• if not motion pro will make u one right up. i think it cost me 30ish shipped
• 
  
• #5 Reply
  Posted by GrkGuy on 31 Jan, 2014 07:25
• dont you have +1 steering stem to.
• 
  
• #6 Reply
  Posted by Iceracer on 31 Jan, 2014 07:29
• Or Terry Cable also, if your +1 on the stem you want to get a custom cable.
• 
  
• #7 Reply
  Posted by Dezsled on 31 Jan, 2014 09:34
• Terry cable makes a braided steel throttle cable that looks pretty sweet...
  
  They can make custom cables. They can modify yours also if needed.
  
  I sent motion pro my ltr450 throttle & cable , they gave me a twist throttle kit for the trouble. They said I had the first ltr450 they knew of! Thank you again Larry
• 
  
• #8 Reply
  Posted by LT250RWV on 31 Jan, 2014 10:12
• Thanks for the help guys.
•