+-
« previous next »
Pages: [1]   Go Down

Author Topic: Possibility of diy mikuni 34mm taper boring  (Read 847 times)

Offline

  • Trade Count: (0)
  • Pro Member
  • ********
  • Posts: 853
  • Gender: Male
  • Location: Chatam NY Upstate
Re: Possibility of diy mikuni 34mm taper boring
« on: February 22, 2013, 08:14:44 pm »
Honestly, I would like to see it happen. Being a 34mm, they are fairly cheap a plentiful (I have 4 or so). I can see a drill press having a few MM variance with a hole saw on the end of it. Trial and error is the corner stone of success! I say try it. Chances are the idle and transition port are going to get mushed over, but if your savvy you might be able  to open them up. more .02
Logged
92 LT250R- Bartlett racing prototype big bore. Wide, Low,  and studded

91 LT250R Mickey Thompson stadium racer

87 LT500R- Mostly stock

89 LT500R IceZilla, mods TBA
Pages: [1]   Go Up
« previous next »
 

+- Suzuki Quadracer HQ Store Zone

http://www.suzukiquadracerhq.com/index.php?action=store