+-
« previous next »
Pages: [1]   Go Down

Author Topic: Possibility of diy mikuni 34mm taper boring  (Read 846 times)

Offline

  • Trade Count: (0)
  • Pro Member
  • ********
  • Posts: 853
  • Gender: Male
  • Location: Chatam NY Upstate
Re: Possibility of diy mikuni 34mm taper boring
« on: February 22, 2013, 10:59:58 am »
You better be awfully accurate with the hole saw. My TM38 was bored to 42.5mm and is extremely thin in spots. I just can't see the teeth on the hole saw not ripping through the engine side of the bore. Just my .02
Logged
92 LT250R- Bartlett racing prototype big bore. Wide, Low,  and studded

91 LT250R Mickey Thompson stadium racer

87 LT500R- Mostly stock

89 LT500R IceZilla, mods TBA
Pages: [1]   Go Up
« previous next »
 

+- Suzuki Quadracer HQ Store Zone

http://www.suzukiquadracerhq.com/index.php?action=store