when you cleaned the carb did you take it completely apart and use a rebuild kit, or did you just reuse old components?

remove the idle screw, should be a screw, spring and maybe an o-ring, clean all components and orifice
remove the air screw, should be a screw, spring and o-ring, clean all components and orifice
remove the slide/needle, should be a needle, clip, spring, retainer, clean all components
remove the main jet, clean the jet and orifice
remove the float assembly, pull the retaining pin
remove the valve jet, should be a needle, clean the needle and orifice
clean the overflow tube
spray carb cleaner throughout the inside of the entire carb

if you really cleaned everything you should have gone through a whole can of carb cleaner

when you put it all back together, set the air screw to 1-1/2 turns out and turn the idle screw all the way in before you put the slide/needle assembly back in, throw it back on and update us. If that doesn't fix the problem, then you may need to look at a new carb