Thank you all for the quick replies.
Dezsled the bearing pockets are tight I warmed (approx 200 degress) the cases in an oven and froze the bearings before installing the bearings and had to gently tap them.
With the crank pulled onto the left side case the crank does not move side to side.
I am measuring the clearance between the right side of crank and the right side bearing. According to the factory manual the smallest shim is too thick and doing a search on line I could not find anyone with a thinner shim. I am guessing they do not exsist.
I found on Mcmaster carr shims that are .015thick but the OD is 2mm bigger. Or do you think the extra clearance will be an issue or run it without any shims?
Gillo Thanks could you check your left over shims for me?
Thank you all again I think I am gonna like Suzuki QHQ
