Quadzilla clutch install

• Quadzilla clutch install
  Posted by Gorillazilla on 16 Jun, 2016 17:05
• I just installed a new clutch kit in my quadzilla and put the cover back on and clutch cable, now when I pull the clutch lever the arm on the cover barely moves and its very hard and will not disengage my clutch
• 
  
• #1 Reply
  Posted by Q2W on 17 Jun, 2016 08:09
• just sounds like it needs adjusting.  take the arm off and move it back a couple of teeth?
  
  When you say it barely moves the arm, does it feel like it's hitting a wall?  or are you able to fully pull the clutch lever in?
• 
  
• #2 Reply
  Posted by Gorillazilla on 22 Jun, 2016 16:01
• I can barely pull the clutch lever the arm moves maybe a quarter of an inch
• 
  
• #3 Reply
  Posted by Q2W on 23 Jun, 2016 06:58
• maybe #14 is in backwards.
  
  
  
  Try re-installing the clutch.
• 
  
• #4 Reply
  Posted by Dutch_Rutter on 23 Jun, 2016 10:27
• Could the #12 bolts be in too tight? or the springs too stiff? There is all kind of possibilities.
• 
  
• #5 Reply
  Posted by Motoman991 on 27 Jun, 2016 10:56
• Quote from: Dutch_Rutter on 23 Jun, 2016 10:27

  Could the #12 bolts be in too tight? or the springs too stiff? There is all kind of possibilities.
  

  
  The #12 bolts can't be installed too tight.  The bolts can only go in so far.  The springs being stiff would make the clutch harder to pull, but it could still be pulled. 
  
  I'm going with what Q2W said.  #14 is installed wrong. 
• 
  
• #6 Reply
  Posted by Dutch_Rutter on 27 Jun, 2016 11:24
• Ah ok, looking back at my build pictures I can see that now. Listen to these guys 
•