Alum Thrust Washer and RM Bearing Wrist Pin Bearing Movement

• Alum Thrust Washer and RM Bearing Wrist Pin Bearing Movement
  Posted by Emann1023 on 12 Nov, 2013 07:55
• I just got DCS thrust washer and bearing kit from the store and when I put it together there is about.030 of an inch movement off the bearing between the washers is that normal.
• 
  
• #1 Reply
  Posted by Mitch Keller on 12 Nov, 2013 13:55
• The width is the same as OEM bearing and thrust washers 25.75 mm, the difference is that the Aluminum thrust washers are thicker by 1mm (no cut step) giving you more side to side protection, also the aluminum harden #7075 alloy is pretty hard material and will expand some as the engine heats up, also the DCS Trust Washers have been tumbled with no sharp edges to cut into the piston pin, if your not happy with your purchase I can offer a RMA and will be happy to refund your money.
• 
  
• #2 Reply
  Posted by Emann1023 on 12 Nov, 2013 16:59
•  all I was wondering is if there was suppose to be that much movement.I want saying I was unhappy with it just asking a question do I know before I put it together and ruin the top end bc of the movement
• 
  
• #3 Reply
  Posted by Zilla273 on 12 Nov, 2013 17:09
• yeah its normal, u should be ok
•