Needle Removal

• Needle Removal
  Posted by Doug123 on 24 Jan, 2014 13:41
• Hi Guys - how do I remove the needle from the slide?  I'm trying to confirm the part # and clip position.  I've looked at it, but I'm not seeing how to do this.
  
  Any help is appreciated.
• 
  
• #1 Reply
  Posted by Rainman56 on 24 Jan, 2014 13:44
• What carb?Stock TM?
• 
  
• #2 Reply
  Posted by Doug123 on 24 Jan, 2014 14:08
• Yep, stock 1992 carb.
• 
  
• #3 Reply
  Posted by Rainman56 on 24 Jan, 2014 15:51
• If I remember correctly should be 2 small screws down there once you get the throttle cable out.Take the screws out and the piece the cable hooks into and you should be able to slide the needle out.
• 
  
• #4 Reply
  Posted by Doug123 on 25 Jan, 2014 05:27
• ok, thanks, but how do I get the plastic piece out that appears to be holding the throttle cable in place?
• 
  
• #5 Reply
  Posted by Roach on 25 Jan, 2014 06:27
• pull the spring all the way up and hold with fingers. then tip slide upside down and it will slide out. then u can yake out the 2 screws. the spring is all that holds the plastic piece in
• 
  
• #6 Reply
  Posted by Roach on 25 Jan, 2014 06:30
• also the plate that holds the needle is slotted for the plastic piece to set in. its a little harder putting back in than taking out but after a few times its a piece of cake
• 
  
• #7 Reply
  Posted by Doug123 on 28 Jan, 2014 06:34
• That did it!  Thanks!
•