motor problems

• motor problems
  Posted by Cavsfan on 23 May, 2015 15:09
• top end rebuilt. ran for 1/2 hour and quit. gets fire and fuel but wont run. think its compression but not sure. looking for suggestions. thanks.
• 
  
• #1 Reply
  Posted by Chadzilla03 on 23 May, 2015 22:23
• Did it backfire, and or "pop" when it quit?
• 
  
• #2 Reply
  Posted by El Diablo on 23 May, 2015 22:50
• How extensive did you go on the rebuild? How does it feel when you kick it over? What fuel and fuel / oil ratio were you running when it quit?
• 
  
• #3 Reply
  Posted by Cavsfan on 25 May, 2015 13:22
• it bogged out like I fouled a plug
  
• 
  
• #4 Reply
  Posted by Cavsfan on 25 May, 2015 13:26
• as far as rebuild, we did everything but the crank and bearings. as for the kicking, it was normal, and fuel and fuel oil ratio 93 octain fuel and oil was 34:1
• 
  
• #5 Reply
  Posted by LTman on 25 May, 2015 14:59
• does it hit at all Maybe take a look at the key in the flywheel
• 
  
• #6 Reply
  Posted by Cavsfan on 25 May, 2015 16:00
• no, it doesn't act like it wants to start, but its getting fire and fuel
• 
  
• #7 Reply
  Posted by Skeans1 on 26 May, 2015 01:45
• Well if you have fuel and spark all you're missing is compression, do a compression test and go from there.
• 
  
• #8 Reply
  Posted by AZ-ZILLA on 26 May, 2015 12:41
• If you have fuel, fire and compression.
  Then timing needs to be verified.....  Check to see if the flywheel key was sheered or not installed during the reassembly.
•