Billet thrust washer question

• Billet thrust washer question
  Posted by lt_250r on 06 Feb, 2014 14:52
• just a quick question are the billet thrust washers tight on the wrist pin ?
  
  i have to push mine to get them on the pin ?
  
  
  
• 
  
• #1 Reply
  Posted by GrkGuy on 06 Feb, 2014 15:40
• it should be a snug fit, where did you get them from.
• 
  
• #2 Reply
  Posted by lt_250r on 06 Feb, 2014 15:52
• From the forum store , there really snug , i can get them on the pin about the thickness of the washer then id have to push hard
• 
  
• #3 Reply
  Posted by Mitch Keller on 06 Feb, 2014 16:42
• Those washers are only .0005" larger OD than the 18mm pin, they are precision made to tolerance and tumbled to de-burr any sharp edges, make sure everything is clean for assembly, I have sold over 80 sets of these washers with out any negative feedback.
• 
  
• #4 Reply
  Posted by lt_250r on 06 Feb, 2014 16:59
• The washers are nice , i just wasnt sure if they where suppose to be tight of abit loose
• 
  
• #5 Reply
  Posted by Mitch Keller on 06 Feb, 2014 17:14
• They will expand as the engine warms up, didn't want them bouncing on the pin like the OEM steel washers can, just remember they are a precision fit on purpose.
• 
  
• #6 Reply
  Posted by lt_250r on 06 Feb, 2014 20:22
• Perfect , You never now its better to ask the questions now then when it grenades ,
  
  BY The way the billet washers from the forum store are great , the shipping was fast , plus there Shiny Haha
  
  thanks alot for the help guys
•