The 2 screws holding down the coil are behind the radiator. looks like Phillips hd screws. Any way to get in there without removing the radiator? Once out i'll replace w/ hex hd. bolts for better way to remove next time. thanks
Pretty sure you will need to remove the radiator.
Get a pair of vice grip regular or needle nose and lock on to the bolt heads from the side, you'll have to replace them but you should be able to get them out W/O pulling the radiator.
I'd replace them with cap heads that way you can use a socket or wrench on them next time.
That's a good Idea for future servicing.
I finally busted the screws loose and turned the new ignition coil around facing the rear of the vehicle and fit like a glove. much easier to get in there to tighten the screws down good n tight!