Anyone ever use these? If so thoughts and or opinions?
I love mine! Great stance, very secure, provide a big boost in handling, super easy to install, no molesting your stock a arms.
Toe isn't set in the first picture.
That upper ball joint looks like it's REAL close to binding up
Probably due to the chit banshee stock shocks I had on when that pic was shot.
To bad these came out after I cut off those tangs
i also hade gotten them but have not installed yet ,do u just install and that is it or do u have to do adjustments?
Just pull the ball joint and factory bolt out insert shim onto ball joint push into a arm and reattach with supplied longer bolt and go. You should check your toe measuments and adjust your tie rods to a slight toe in. Mines set at like 1/8" of toe in if I remember right.
Camber Shim Install Sheet
I wouldn't forget to Loctite the bolts on reassembly.
Lil dab of Blue Lock Tight will do, When you tighten that bolt with 7/8 wrench its on tight, you want to be able to take that bolt out sometime down the road without needing a 125psi impact gun or 6ft cheater bar.
Here's a couple pics from my bike after installing the mod at Glamis this last weekend. After finally getting the bike running I have to say the mod does make a difference, especially when riding the bowls and cresting the razors. It holds the front in a straighter line instead of drifting down with the stock camber.
I am curious to where you guys are getting the camber shims from.
Does anyone know where I can buy Camber shims? The website below shows out of stock.
Having some made should be done soon.
Put me down for a set mitch please
Sorry didn't read what quad these were for .
NEED FOR A 87 500 mitch.( Not sure if they interchange)
That is good news. Put me down for 2 sets please.
Does anyone know what I should set toe in to after camber adjustment and bump steer mod?
