Hybrid question

• Hybrid question
  Posted by Maxxh2o on 28 Jan, 2013 14:39
• If one was to convert a 87+ lt250 into a 250/500 hybrid, after the frame mods are done for the 500 engine, can you put a 250 back in the frame with no welding?  Thx
• 
  
• #1 Reply
  Posted by Stpltn250r on 28 Jan, 2013 15:00
• I would say the lower motor mount would need some bigger spacers.
• 
  
• #2 Reply
  Posted by Iceracer on 28 Jan, 2013 16:50
• Ye,s you just need to make wider spacer for the one side. I swap mine back an forth.
• 
  
• #3 Reply
  Posted by Maxxh2o on 08 Feb, 2013 14:57
• Thanks. I'm assuming that this is if you do not move the swingarm pivot location.
  
  Thanks guys.
• 
  
• #4 Reply
  Posted by GrkGuy on 08 Feb, 2013 15:12
• one thing that everyone forgets to say is with a q pipe it comes very close to the front a arms
  i think if you compress the front suspension it will hit the a arms, thats why most guys go +1 foward
  
• 
  
• #5 Reply
  Posted by Maxxh2o on 08 Feb, 2013 15:19
• If I go forward with this I had planned to run a trx or yfz front end.
• 
  
• #6 Reply
  Posted by Quadster on 08 Feb, 2013 19:41
• No need to move the pivot for the swap. I used the 250 swinger bolt.
•