+-
« previous next »
Pages: 1 2 3 [4]   Go Down

Author Topic: 38 vs 42.5 mm  (Read 4056 times)

Offline

  • Trade Count: (0)
  • Forum Moderator
  • Pro Member
  • *********
  • Posts: 860
  • Gender: Male
  • Location: SoCal
Re: 38 vs 42.5 mm
« Reply #75 on: November 26, 2013, 08:01:53 am »
Quote from: Dezsled on November 25, 2013, 06:09:20 pm
Sorry I'm late to the swap... Does this carb bolt on to oem Zilla intake/airbox boots?

If you're talking about a VM44, if JH modifies it for you he will turn down the OD on the bells and you can boil your intake boot then fit it on the carb & let it cool.  it'll work with good with just a little struggle getting it on and off.

Logged

Offline

  • Trade Count: (0)
  • Forum Moderator
  • Elite Member
  • *********
  • Posts: 2058
Re: 38 vs 42.5 mm
« Reply #76 on: November 26, 2013, 10:54:13 am »
Yeah that's the one Bret. Thanks for the info.

Like I keep saying its hard to believe that this HPR motor will run any harder. It's already violent & dangerous....   :))
Logged
87 HPR LT500
04 Roll LOBO II TRX250R
06 LTR450
87 LT500
85 & 86 LT250
86 & 87 TRX250R
07 & 09 Husqvarna TE450
00 CR125R

Offline

  • Trade Count: (0)
  • Range Rover
  • *****
  • Posts: 381
  • Gender: Male
  • Location: watertown ny
Re: 38 vs 42.5 mm
« Reply #77 on: November 26, 2013, 11:09:08 am »
I just did my 250 carb boot to match my 41pwk, i heated it carefully with a propane torch and slowly pushed an inch n 7/8 truck ball into it then ran under cold water, it worked perfect :))
Logged
Pages: 1 2 3 [4]   Go Up
« previous next »
 

+- Suzuki Quadracer HQ Store Zone

http://www.suzukiquadracerhq.com/index.php?action=store