+-
« previous next »
Pages: [1]   Go Down

Author Topic: oversize  (Read 1023 times)

Offline Quadracer

  • Trade Count: (0)
  • Newbie
  • **
  • Posts: 13
oversize
« on: September 13, 2016, 04:49:22 pm »
Hi guys, I recently oversized my 500 88, 88mm to 89mm. I want to know if i need a bigger jet in the carb. IT was running good before the compression problem. Now It run good at low thru mid range but after that, it run like they missing gas or air. i just do the oversize, no more modif on it. I run FMF pipe and silencer, 38mm mikuni and radvalve with boysen proseries reeds. Run with the airbox no lid with KN filter.
Tks
Logged

Share on Facebook Share on Twitter

Offline ZillaFreak

  • Trade Count: (0)
  • Range Rover
  • *****
  • Posts: 503
Re: oversize
« Reply #1 on: September 14, 2016, 05:28:55 am »
Should you have to rejet for doing an overbore job, no.
Should you check your jetting, yes.

Also check your jetting when you do something. Better safe than sorry.
Logged

Offline Q2W

  • Trade Count: (0)
  • Forum Moderator
  • Elite Member
  • *********
  • Posts: 1386
  • Gender: Male
  • Location: NWA
Re: oversize
« Reply #2 on: September 14, 2016, 06:22:47 am »
Your jetting usually changes as your compression changes.
Logged

Offline Glamisrider

  • Trade Count: (0)
  • Forum Moderator
  • Pro Member
  • *********
  • Posts: 860
  • Gender: Male
  • Location: SoCal
Re: oversize
« Reply #3 on: September 19, 2016, 10:28:16 am »
You can always try it and see how it does with a bigger jet in it.

If it does not work then you can always go back.

Logged
Pages: [1]   Go Up
« previous next »
 

+- Suzuki Quadracer HQ Store Zone

http://www.suzukiquadracerhq.com/index.php?action=store