+-
« previous next »
Pages: [1]   Go Down

Author Topic: Kill Switch  (Read 499 times)

Offline

  • Trade Count: (0)
  • Newbie
  • **
  • Posts: 24
  • Gender: Male
  • Location: Oroville, CA
Kill Switch
« on: January 05, 2014, 06:08:27 pm »
The Kill switch on my 88 LT250R does not work.  What wires do I need to look at to try and figure out if my switch is bad or if the problem is something else.  The bike runs great and I have just been using the key as the kill switch.  Lights work fine as well.
Logged

Share on Bluesky Share on Facebook

Offline

  • Trade Count: (0)
  • Newbie
  • **
  • Posts: 17
Re: Kill Switch
« Reply #1 on: January 05, 2014, 06:38:45 pm »
Check your grounds or the internals of the kill switch could be shot.
Logged

Offline

  • Trade Count: (0)
  • Range Rover
  • *****
  • Posts: 463
Re: Kill Switch
« Reply #2 on: January 05, 2014, 09:12:17 pm »
I had a solder joint pop loose on a kill switch. Re-soldered and it was good to go.

Pop the switch open and take a look.
Logged
Pages: [1]   Go Up
« previous next »
 

+- Suzuki Quadracer HQ Store Zone

http://www.suzukiquadracerhq.com/index.php?action=store