Author Topic: Exhaust valve rod fell off. (Read 953 times)

Protoolsuser81 · « **on:** January 04, 2014, 06:16:17 pm »

I looked through the little glass window on my 90 lt250r and noticed the rod and white clip came out and was disconnected to the valve. I took the little window section off and attached the rod. When I reved the engine a little I didn't see any movement. Is there a way to adjust this or some.steps I should take to sort this out?

PCS · « **Reply #1 on:** January 04, 2014, 07:02:36 pm »

did you try resetting the adjustment after you reconnected everything.

Protoolsuser81 · « **Reply #2 on:** January 04, 2014, 07:35:32 pm »

Nope, is that the dial on the opposite side of the engine? Could you give me a quick walkthrough of what I should do?

Protoolsuser81 · « **Reply #3 on:** January 20, 2014, 12:05:23 pm »

Well that little plastic bushing seems to not be holding that rod in very well as it fell out again. Any tricks to get this to stay in or should I just order a new bushing/plastic clip?

LT500Kid · « **Reply #4 on:** January 20, 2014, 01:31:04 pm »

Those clips break easily. Go to Suzuki dealer and get new ones. I bought 3 top ones and 3 bottom ones last time I needed them they are super cheap and if you break one next time you will have an extra one.

Protoolsuser81 · « **Reply #5 on:** January 21, 2014, 11:29:31 am »

Yea i'm just going to order a few of them. Good call.

News:

Author Topic: Exhaust valve rod fell off. (Read 953 times)

Protoolsuser81

Exhaust valve rod fell off.

PCS

Re: Exhaust valve rod fell off.

Protoolsuser81

Re: Exhaust valve rod fell off.

Protoolsuser81

Re: Exhaust valve rod fell off.

LT500Kid

Re: Exhaust valve rod fell off.

Protoolsuser81

Re: Exhaust valve rod fell off.

Suzuki Quadracer HQ Store Zone