Author Topic: bad head ?? (Read 442 times)

Jsmitty42 · « **on:** October 24, 2013, 11:39:57 am »

is this head good ?

Iceracer · « **Reply #1 on:** October 24, 2013, 11:51:27 am »

Looks like it should be re machined. has had some thing go through it ring or washer and looks like it has been run lean or on shitty fuel looks like a lot of detonation.

Jsmitty42 · « **Reply #2 on:** October 24, 2013, 12:01:55 pm »

what would happen if i didnt remachine it ?

Nekrofilliak · « **Reply #3 on:** October 24, 2013, 12:09:05 pm »

iceracer is right, but it should work without problem.

Iceracer · « **Reply #4 on:** October 24, 2013, 12:13:25 pm »

It may detonate some but the reality is most of them do until they are corrected, some run for years some blow through head gaskets and cause other issues. be sure there are no pointed peaks on the squish band, smooth them out with a little fine sand paper. you can run the gasket surface on a piece of glass and 220 grit sand paper to get all the gasket material off and see if has a low spot.

All American · « **Reply #5 on:** October 24, 2013, 12:15:05 pm »

I've watched my grandpa sand down tractor parts the way ice racer just described. Lol

News:

Author Topic: bad head ?? (Read 442 times)

Jsmitty42

bad head ??

Iceracer

Re: bad head ??

Jsmitty42

Re: bad head ??

Nekrofilliak

Re: bad head ??

Iceracer

Re: bad head ??

All American

Re: bad head ??

Suzuki Quadracer HQ Store Zone