Author Topic: Alum Thrust Washer and RM Bearing Wrist Pin Bearing Movement (Read 368 times)

Emann1023 · « **on:** November 12, 2013, 07:55:52 am »

I just got DCS thrust washer and bearing kit from the store and when I put it together there is about.030 of an inch movement off the bearing between the washers is that normal.

Mitch Keller · « **Reply #1 on:** November 12, 2013, 01:55:21 pm »

The width is the same as OEM bearing and thrust washers 25.75 mm, the difference is that the Aluminum thrust washers are thicker by 1mm (no cut step) giving you more side to side protection, also the aluminum harden #7075 alloy is pretty hard material and will expand some as the engine heats up, also the DCS Trust Washers have been tumbled with no sharp edges to cut into the piston pin, if your not happy with your purchase I can offer a RMA and will be happy to refund your money.

Emann1023 · « **Reply #2 on:** November 12, 2013, 04:59:37 pm »

all I was wondering is if there was suppose to be that much movement.I want saying I was unhappy with it just asking a question do I know before I put it together and ruin the top end bc of the movement

Zilla273 · « **Reply #3 on:** November 12, 2013, 05:09:14 pm »

yeah its normal, u should be ok

News:

Author Topic: Alum Thrust Washer and RM Bearing Wrist Pin Bearing Movement (Read 368 times)

Emann1023

Alum Thrust Washer and RM Bearing Wrist Pin Bearing Movement

Mitch Keller

Re: wrist pin bearing movement

Emann1023

Re: Alum Thrust Washer and RM Bearing Wrist Pin Bearing Movement

Zilla273

Re: Alum Thrust Washer and RM Bearing Wrist Pin Bearing Movement

Suzuki Quadracer HQ Store Zone