Author Topic: Quadzilla clutch install (Read 1244 times)

Gorillazilla · « **on:** June 16, 2016, 05:05:16 pm »

I just installed a new clutch kit in my quadzilla and put the cover back on and clutch cable, now when I pull the clutch lever the arm on the cover barely moves and its very hard and will not disengage my clutch

Q2W · « **Reply #1 on:** June 17, 2016, 08:09:00 am »

just sounds like it needs adjusting. take the arm off and move it back a couple of teeth?

When you say it barely moves the arm, does it feel like it's hitting a wall? or are you able to fully pull the clutch lever in?

Gorillazilla · « **Reply #2 on:** June 22, 2016, 04:01:52 pm »

I can barely pull the clutch lever the arm moves maybe a quarter of an inch

Q2W · « **Reply #3 on:** June 23, 2016, 06:58:15 am »

maybe #14 is in backwards.

Try re-installing the clutch.

Dutch_Rutter · « **Reply #4 on:** June 23, 2016, 10:27:40 am »

Could the #12 bolts be in too tight? or the springs too stiff? There is all kind of possibilities.

Motoman991 · « **Reply #5 on:** June 27, 2016, 10:56:36 am »

Quote from: Dutch_Rutter on June 23, 2016, 10:27:40 am

Could the #12 bolts be in too tight? or the springs too stiff? There is all kind of possibilities.

The #12 bolts can't be installed too tight. The bolts can only go in so far. The springs being stiff would make the clutch harder to pull, but it could still be pulled.

I'm going with what Q2W said. #14 is installed wrong.

Dutch_Rutter · « **Reply #6 on:** June 27, 2016, 11:24:54 am »

Ah ok, looking back at my build pictures I can see that now. Listen to these guys

News:

Author Topic: Quadzilla clutch install (Read 1244 times)

Gorillazilla

Quadzilla clutch install

Q2W

Re: Quadzilla clutch install

Gorillazilla

Re: Quadzilla clutch install

Q2W

Re: Quadzilla clutch install

Dutch_Rutter

Re: Quadzilla clutch install

Motoman991

Re: Quadzilla clutch install

Dutch_Rutter

Re: Quadzilla clutch install

Suzuki Quadracer HQ Store Zone