+-
« previous next »
Pages: [1]   Go Down

Author Topic: Billet thrust washer question  (Read 455 times)

Offline

  • Trade Count: (0)
  • Newbie
  • **
  • Posts: 8
Billet thrust washer question
« on: February 06, 2014, 02:52:56 pm »
just a quick question are the billet thrust washers tight on the wrist pin ?

i have to push mine to get them on the pin ?


Logged

Share on Bluesky Share on Facebook

Offline

  • Trade Count: (0)
  • Elite Member
  • **********
  • Posts: 2209
  • Gender: Male
  • Location: ohio
Re: Billet thrust washer question
« Reply #1 on: February 06, 2014, 03:40:33 pm »
it should be a snug fit, where did you get them from.
Logged
life's journey is not to arrive at the grave safely in a well preserved body, but rather to skid in sidays totally worn out shouting "HOLY SH*T...WHAT A RIDE!"

Offline

  • Trade Count: (0)
  • Newbie
  • **
  • Posts: 8
Re: Billet thrust washer question
« Reply #2 on: February 06, 2014, 03:52:18 pm »
From the forum store , there really snug , i can get them on the pin about the thickness of the washer then id have to push hard
Logged

Offline

  • Mitch Keller
  • Trade Count: (0)
  • Administrator
  • Trail Blazer
  • *****
  • Posts: 799
  • Love The Smell Of 927 and Race Fuel In The Morning
  • Location: Riverside Ca
Re: Billet thrust washer question
« Reply #3 on: February 06, 2014, 04:42:48 pm »
Those washers are only .0005" larger OD than the 18mm pin, they are precision made to tolerance and tumbled to de-burr any sharp edges, make sure everything is clean for assembly, I have sold over 80 sets of these washers with out any negative feedback.
Logged
F Mitch Keller

Offline

  • Trade Count: (0)
  • Newbie
  • **
  • Posts: 8
Re: Billet thrust washer question
« Reply #4 on: February 06, 2014, 04:59:27 pm »
The washers are nice , i just wasnt sure if they where suppose to be tight of abit loose
Logged

Offline

  • Mitch Keller
  • Trade Count: (0)
  • Administrator
  • Trail Blazer
  • *****
  • Posts: 799
  • Love The Smell Of 927 and Race Fuel In The Morning
  • Location: Riverside Ca
Re: Billet thrust washer question
« Reply #5 on: February 06, 2014, 05:14:23 pm »
They will expand as the engine warms up, didn't want them bouncing on the pin like the OEM steel washers can, just remember they are a precision fit on purpose.
Logged
F Mitch Keller

Offline

  • Trade Count: (0)
  • Newbie
  • **
  • Posts: 8
Re: Billet thrust washer question
« Reply #6 on: February 06, 2014, 08:22:51 pm »
Perfect , You never now its better to ask the questions now then when it grenades ,

BY The way the billet washers from the forum store are great , the shipping was fast , plus there Shiny Haha

thanks alot for the help guys
Logged
Pages: [1]   Go Up
« previous next »
 

+- Suzuki Quadracer HQ Store Zone

http://www.suzukiquadracerhq.com/index.php?action=store