Not looking for a stock one and I'm not looking to buy one if anyone is in the middle of a rebuild or could do without their skid plate for two weeks or less I just want one for measurements to have my own cut and welded together. I'll cover shipping to and from.

Yes sir the solid one piece that bolts on with the carrier bolts and protects the sprocket and rotor. Not the oem 4 piece pos.

Yeah Dez I know I have a 3x12 sheet of 1/8" diamond plate aluminum and a good friend of my dads is a good aluminum welder. If I could get the demensions to cut the roughly 7 pieces of aluminum I could have one made for under $40.

1/8th inch is not going to be strong enough for a rear skid.  one hit and it'll bend up into your disc or sprocket.  most good skids are made from 1/4 aluminum

unless your running in the sand or groomed trails i'd go thicker

Are those off your zillas Dez?

And I will be reinforcing the skid plate SBLT not just doing a single sheet cut one off of the aftermarket skid plates.

Here's afew out of the past to present

L-R stock oem trx250r, home made for trx250r '86, Doug Roll Design & Developement DRD&D '89, Badger heat treated chromoly steel (heavy)'04,  home made for roll lobo ll swingarm ' 10

Buckeye--you find a skid plate yet?  I have a brand spankin new PRM measures .0261 thick,  I ran the same one for 10 years and its beat and looks like sheit but it held up and protected everything well.

If you need one to mock something up I can part with it for up to two weeks.  If you want to cover the shipping just PM me your address and I will mail it out and you can reimburse me via check or pay pal.  Say the word and its yours for 2 weeks.   I will try to attach some pictures here but i am techno picture handicaped here
Let me know