Suzuki Quadracer HQ

LT500R Quadracer => LT500R - Engine => Topic started by: Petenorth on November 17, 2012, 04:30:28 pm

Title: Re: Adjusting powervalve
Post by: WestTexasKing on November 17, 2012, 06:37:34 pm

Nope, just hook the rod up to the powervalve and install the window.
From there, index the cap to the spring with the powervalve in the open position, turn it 1-2 turns CCW depending on your pipe.
Search the forum for my post on how to fine tune the powervalve to your engine and pipe.

Title: Re: Adjusting powervalve
Post by: Mitch Keller on November 17, 2012, 06:07:37 pm

Heck I cant remember was it to tighten the spring Clockwise or Counter Clockwise?

Title: Re: Adjusting powervalve
Post by: Petenorth on November 17, 2012, 05:18:45 pm

Thanks for the info. Do you you do anything on the side with the window other than hook the rod up?

Title: Re: Adjusting powervalve
Post by: Reddog815 on November 17, 2012, 04:56:41 pm

I snapped the page in the manual.

Title: Re: Adjusting powervalve
Post by: Dust360 on November 17, 2012, 04:51:39 pm

turn the spring counter clockwise 1 turn after pulling cover off and it is sitting in non-running position

Title: Re: Adjusting powervalve
Post by: Dezsled on November 17, 2012, 04:45:47 pm

Yeah ...preloading the spring ? Double oring the chingas...?

Title: Adjusting powervalve
Post by: Petenorth on November 17, 2012, 04:30:28 pm

How do you adjust the powervalve correctly? Once you put the cylinder on, hook the rod up. Start from there please. Thanks