Suzuki Quadracer HQ

Suzuki Quadracer HQ Discussion => Suzuki Quadracer HQ - General Discussion => Topic started by: Mitch Keller on November 10, 2012, 10:10:40 am

Title: Re: Does Any One Make 8mm x 1.125 Lug Nuts?
Post by: SBLT500R on November 10, 2012, 08:45:17 pm

you can get ss flange nuts.  m8 X 1.25  or zinc plated if you didn't want ss.

or order up cylinder nuts.  ordered some before should be cr cylinder nuts.  were cheaper then the kx nuts i needed. 

stupid suzuki had to use small studs on the front hubs.   every other quad uses m10's. 

Title: Re: Does Any One Make 8mm x 1.125 Lug Nuts?
Post by: Mitch Keller on November 10, 2012, 06:32:50 pm

Went looking didnt see any listed, only 10mm and 12mm

Title: Re: Does Any One Make 8mm x 1.125 Lug Nuts?
Post by: Iceracer on November 10, 2012, 10:58:27 am

Rocky mountain Atv has them.

Title: Re: Does Any One Make 8mm x 1.125 Lug Nuts?
Post by: Dezsled on November 10, 2012, 10:16:47 am

Aren't those 8x1.125 standard flange nuts you can get like at Honda?

Title: Does Any One Make 8mm x 1.125 Lug Nuts?
Post by: Mitch Keller on November 10, 2012, 10:10:40 am

Found a load of the 10mm x 1.25 lug nuts, wondering if any seen 8mm x 1.125 lug nuts??