Suzuki Quadracer HQ

Suzuki Quadracer HQ Discussion => Suzuki Quadracer HQ - General Discussion => Topic started by: LTman on May 20, 2020, 09:38:29 am

Title: Re: Steering stem bearing
Post by: Gaz on February 24, 2021, 08:40:02 am

Is this to replace the lower stem bushing that is pressed into the frame? If it is, how is the needle bearing going handle the axial load from the steering stem? Is it a tapered bearing? Are you using a thrust washer? Otherwise, the stem will just rub on the top of the bushing pocket in the frame. Cheers.

Title: Re: Steering stem bearing
Post by: 2StrokeBandit on June 16, 2020, 01:36:38 am

bought the bras one already but thx anyway ... good to know for the future !

Title: Re: Steering stem bearing
Post by: Andys92 on June 02, 2020, 04:16:31 am

This work with 250and 500.Are the stems etc the same size?

Title: Re: Steering stem bearing
Post by: Andys92 on May 20, 2020, 12:04:45 pm

That's good to know thanks

Title: Steering stem bearing
Post by: LTman on May 20, 2020, 09:38:29 am

I've found a bearing that fits perfect to replace the steering stem bushing 
It's got a inter sleeve so it will fix your worn out stem
I got mine from eBay bearing number HK172630
It was easy install I pushed the bearing in from the bottom after pushing it in I cut the old bushing down to fit the top part of the hole then installed it