Suzuki Quadracer HQ
LT250R Quadracer => LT250R - General Discussion => Topic started by: Sir Robert vag Bashington III on June 04, 2017, 12:11:23 pm
-
That's the PArt # not rod length, its a CK105 128 mm Hot Rods Kit. Spacer may be an attempt to change port timing on the Cheap, or correcting for a different Piston pin height.
-
how thick is the base plate?
-
Hello I just bought a lt250r quadracer and it had a broken stud on the base of the jugs. I remove the jugs to repair the stud and there was a gasket and a copper gasket or base plate underneath that. I'm not sure if a previous owner doubled up gaskets or this is some sort of spacer plate for a stroker crank. I noticed it has a 105mm hot rods rod but can't make out any piston numbers. So my question is is this a gasket or some sort of spacer plate for that strut for a stroker crank