Suzuki Quadracer HQ

LT250R Quadracer => LT250R - Engine => Topic started by: Miskei03 on July 03, 2016, 07:23:45 pm

Title: Re: 86 crank??
Post by: Miskei03 on July 05, 2016, 03:20:45 pm

Just in and out top of rotation.

Title: Re: 86 crank??
Post by: El Diablo on July 05, 2016, 03:19:45 pm

What about up/down an front /back movement?

Title: Re: 86 crank??
Post by: Miskei03 on July 05, 2016, 02:07:57 pm

Ok pulled the flywheel cover and it moves a little in and out when I pull on it. So I shouldn't run it?

Title: Re: 86 crank??
Post by: Miskei03 on July 04, 2016, 03:50:41 pm

Yea I just did some reading on Jerry halls webpage and I think it may need new inserts. I hope not but I'll check it and reply back. Thanks alot.

Title: Re: 86 crank??
Post by: El Diablo on July 04, 2016, 03:47:50 pm

That's what I would do

Title: Re: 86 crank??
Post by: Miskei03 on July 04, 2016, 02:13:56 pm

Ok so do I just pull flywheel cover and inspect flywheel for movement?

Title: Re: 86 crank??
Post by: El Diablo on July 04, 2016, 01:05:13 pm

Sounds like crankshafts bearings. Might be time to get them replaced.

Title: 86 crank??
Post by: Miskei03 on July 03, 2016, 07:23:45 pm

Ok I just had my top end bored and put in new top end kit and I noticed some play in the crank. It moves when the crank is at the top of rotation side to side. I'm not talking about the rod it self I mean the bottom of the crank. Is it normal? I put in billet thrust washers and 98 RM wrist pin. Don't wanna mess it up anymore then it already is so I appreciate the help.