Suzuki Quadracer HQ

LT500R Quadracer => LT500 - General Discussion => Topic started by: Gorillazilla on June 16, 2016, 05:05:16 pm

Title: Re: Quadzilla clutch install
Post by: Dutch_Rutter on June 27, 2016, 11:24:54 am

Ah ok, looking back at my build pictures I can see that now. Listen to these guys  +k2

Title: Re: Quadzilla clutch install
Post by: Motoman991 on June 27, 2016, 10:56:36 am

Quote from: Dutch_Rutter on June 23, 2016, 10:27:40 am

Could the #12 bolts be in too tight? or the springs too stiff? There is all kind of possibilities.

The #12 bolts can't be installed too tight.  The bolts can only go in so far.  The springs being stiff would make the clutch harder to pull, but it could still be pulled. 

I'm going with what Q2W said.  #14 is installed wrong. 

Title: Re: Quadzilla clutch install
Post by: Dutch_Rutter on June 23, 2016, 10:27:40 am

Could the #12 bolts be in too tight? or the springs too stiff? There is all kind of possibilities.

Title: Re: Quadzilla clutch install
Post by: Q2W on June 23, 2016, 06:58:15 am

maybe #14 is in backwards.

(http://i.imgur.com/OPzSksG.gif)

Try re-installing the clutch.

Title: Re: Quadzilla clutch install
Post by: Gorillazilla on June 22, 2016, 04:01:52 pm

I can barely pull the clutch lever the arm moves maybe a quarter of an inch

Title: Re: Quadzilla clutch install
Post by: Q2W on June 17, 2016, 08:09:00 am

just sounds like it needs adjusting.  take the arm off and move it back a couple of teeth?

When you say it barely moves the arm, does it feel like it's hitting a wall?  or are you able to fully pull the clutch lever in?

Title: Quadzilla clutch install
Post by: Gorillazilla on June 16, 2016, 05:05:16 pm

I just installed a new clutch kit in my quadzilla and put the cover back on and clutch cable, now when I pull the clutch lever the arm on the cover barely moves and its very hard and will not disengage my clutch