Suzuki Quadracer HQ

LT500R Quadracer => LT500R - Body / Chassis / Suspension => Topic started by: Raiderzilla on March 16, 2016, 02:18:35 pm

Title: Re: A-arms Tap and die
Post by: jonbon540 on March 18, 2016, 08:58:07 am

I also have a set of lowers done like that. just that grease zerk is on the top side and very close to the dust cap seal twords the end , on mine.

Title: Re: A-arms Tap and die
Post by: Q2W on March 17, 2016, 02:08:56 pm

They are stock.  A bit dirty but i really like the chrome look too.

Title: Re: A-arms Tap and die
Post by: Raiderzilla on March 17, 2016, 01:37:12 pm

Nice, thanks Q2W. Are those stockers or aftermarket? I like the chrome look. I was thinking of powder coating mine black.

Title: Re: A-arms Tap and die
Post by: Q2W on March 17, 2016, 11:17:38 am

(http://i.imgur.com/IIcCgdVl.jpg)

(http://i.imgur.com/zbX5FuNl.jpg)

Title: Re: A-arms Tap and die
Post by: Q2W on March 17, 2016, 07:45:32 am

I have them on mine.

Ill post some pics at lunch.

Title: Re: A-arms Tap and die
Post by: ZillaFreak on March 17, 2016, 05:50:08 am

Never done it to a-arms, but have done it to carriers.

It isn't hard. Just make sure you put it somewhere it wont be ripped off from the a-arms moving.

Title: A-arms Tap and die
Post by: Raiderzilla on March 16, 2016, 02:18:35 pm

Has anyone here ever tapped and put on zirk fittings on their stock 500 A-arms? I have seen zirk fittings on newer quad a-arms but am wondering if anyone has done this on the stockers and where exactly you put them? Pics would be cool to see the finished product.