Suzuki Quadracer HQ

Suzuki Quadracer HQ Discussion => Suzuki Quadracer HQ - General Discussion => Topic started by: 4-tracker on February 08, 2016, 01:39:19 pm

Title: Re: ignition coil removal problem!
Post by: 4-tracker on February 17, 2016, 12:41:34 pm

I finally busted the screws loose and turned the new ignition coil around facing the rear of the vehicle and fit like a glove. much easier to get in there to tighten the screws down good n tight!

Title: Re: ignition coil removal problem!
Post by: 4-tracker on February 11, 2016, 06:06:06 am

That's a good Idea for future servicing.

Title: Re: ignition coil removal problem!
Post by: Glamisrider on February 10, 2016, 03:05:01 pm

Get a pair of vice grip regular or needle nose and lock on to the bolt heads from the side, you'll have to replace them but you should be able to get them out W/O pulling the radiator.

I'd replace them with cap heads that way you can use a socket or wrench on them next time.

Title: Re: ignition coil removal problem!
Post by: Motoman991 on February 09, 2016, 11:04:02 am

Pretty sure you will need to remove the radiator.

Title: ignition coil removal problem!
Post by: 4-tracker on February 08, 2016, 01:39:19 pm

The 2 screws holding down the coil are behind the radiator. looks like Phillips hd screws. Any way to get in there without removing the radiator? Once out i'll replace w/ hex hd. bolts for better way to remove next time. thanks