Suzuki Quadracer HQ

LT250R Quadracer => LT250R - Engine => Topic started by: Cavsfan on May 23, 2015, 03:09:22 pm

Title: Re: motor problems
Post by: AZ-ZILLA on May 26, 2015, 12:41:40 pm

If you have fuel, fire and compression.
Then timing needs to be verified.....  Check to see if the flywheel key was sheered or not installed during the reassembly.

Title: Re: motor problems
Post by: Skeans1 on May 26, 2015, 01:45:56 am

Well if you have fuel and spark all you're missing is compression, do a compression test and go from there.

Title: Re: motor problems
Post by: Cavsfan on May 25, 2015, 04:00:57 pm

no, it doesn't act like it wants to start, but its getting fire and fuel

Title: Re: motor problems
Post by: LTman on May 25, 2015, 02:59:34 pm

does it hit at all Maybe take a look at the key in the flywheel

Title: Re: motor problems
Post by: Cavsfan on May 25, 2015, 01:26:20 pm

as far as rebuild, we did everything but the crank and bearings. as for the kicking, it was normal, and fuel and fuel oil ratio 93 octain fuel and oil was 34:1

Title: Re: motor problems
Post by: Cavsfan on May 25, 2015, 01:22:47 pm

it bogged out like I fouled a plug

Title: Re: motor problems
Post by: El Diablo on May 23, 2015, 10:50:10 pm

How extensive did you go on the rebuild? How does it feel when you kick it over? What fuel and fuel / oil ratio were you running when it quit?

Title: Re: motor problems
Post by: Chadzilla03 on May 23, 2015, 10:23:17 pm

Did it backfire, and or "pop" when it quit?

Title: motor problems
Post by: Cavsfan on May 23, 2015, 03:09:22 pm

top end rebuilt. ran for 1/2 hour and quit. gets fire and fuel but wont run. think its compression but not sure. looking for suggestions. thanks.