Suzuki Quadracer HQ
Suzuki Quadracer HQ Galleries => Video / YouTube => Topic started by: Zilla273 on May 19, 2014, 01:59:33 pm
-
Yeah the rubber paddles roll over really easy, i have some 8paddle haulers i wana try on it just gota put them on rims
-
I ran those on my ltr and they work but the rubber is reall soft and after a whole season the paddle started to crack. I dont leave my paddle on the quad either when its parked. On the hard packed sand the paddle would bend back bc it was too soft. Timefor some skat traks
-
Anyway here is pic of 250tires
-
Engine
-
Got my mind on getin this to next race as of now lol
-
Pc its 300ft, i run 20inch tires on 8inch wheel, there 8paddle sand snakes. Just cheapies
-
I was talkin about stock cylinder 4mill, 2c
-
Alot of the cylinder setup have to have .250 spacer plate. 363 sphinix is setup not to run spacer. Even if its a long rod motor they have to have .190 plate to run 86 piston. Im running spacer on my 4mil esr 310 pv. I just seen a 4 mil 310 put down very close to 58hp and 37 torque on pump gas a couple days ago.
-
What size wheel and how long of a race
-
I launch in 1rst with this gearing with 21in 8paddle sand snakes, 2nd is alittle to much, id like to try 13 on front for 2nd gear launch to see if its any better.
-
What gear you launch at with that gearing?Whta size tires?Just curious.Sounds like you have that 250 screaming really well.
-
Went back to this track today to play around with buddys, i had my dynoport pipe on with 14-39 gears, i ran 3tenths faster then i did at this previous race and was more consistant, i may have a shot at winning next race +k2
-
Some ppl build them with out spacer and machine cylinder head 2mm plus or minus to sett squish clearance. I think most ppl prefer that route, but idk really not much of a hondabater _^_
-
Owner said it was, otherwise i wouldnt no, didnt have spacer set up
probably a stock crank hahaha
-
i was just messing around with ya
-
Shank Jr. The trx I just bought spank my lt ass. Not a fair fight.
-
Owner said it was, otherwise i wouldnt no, didnt have spacer set up
-
how do you know it had a 4mil engine -->
good race none the less
-
Whoa whoa slow down buddy. You just saw a Suzuki beat a more modified trx250r
-
Wish I could get my 250 to run like yours. Im so sick of it I bought trx250r.
-
Sweet!
-
Nice run! Get him some likes!
-
ended up geting 2nd out of 6 250rs, beat some esr cylinder bikes, 1rst place was a d&d built 250r that was set up for drag with plus6 swinger aluminum drag axle the hole9 yards
-
Nice job man
-
Shank put it up
-
https://www.youtube.com/watch?v=JCCsFZFBPeQ&feature=youtu.be
-
Where is the video?I ain,t seeing it?
-
Better than wacking off. Now where's the vid. -->
-
what the hey my phone keeps wacking out
-
;D