Suzuki Quadracer HQ

LT250R Quadracer => LT250R - Engine => Topic started by: lt_250r on February 06, 2014, 02:52:56 pm

Title: Re: Billet thrust washer question
Post by: lt_250r on February 06, 2014, 08:22:51 pm

Perfect , You never now its better to ask the questions now then when it grenades ,

BY The way the billet washers from the forum store are great , the shipping was fast , plus there Shiny Haha

thanks alot for the help guys

Title: Re: Billet thrust washer question
Post by: Mitch Keller on February 06, 2014, 05:14:23 pm

They will expand as the engine warms up, didn't want them bouncing on the pin like the OEM steel washers can, just remember they are a precision fit on purpose.

Title: Re: Billet thrust washer question
Post by: lt_250r on February 06, 2014, 04:59:27 pm

The washers are nice , i just wasnt sure if they where suppose to be tight of abit loose

Title: Re: Billet thrust washer question
Post by: Mitch Keller on February 06, 2014, 04:42:48 pm

Those washers are only .0005" larger OD than the 18mm pin, they are precision made to tolerance and tumbled to de-burr any sharp edges, make sure everything is clean for assembly, I have sold over 80 sets of these washers with out any negative feedback.

Title: Re: Billet thrust washer question
Post by: lt_250r on February 06, 2014, 03:52:18 pm

From the forum store , there really snug , i can get them on the pin about the thickness of the washer then id have to push hard

Title: Re: Billet thrust washer question
Post by: GrkGuy on February 06, 2014, 03:40:33 pm

it should be a snug fit, where did you get them from.

Title: Billet thrust washer question
Post by: lt_250r on February 06, 2014, 02:52:56 pm

just a quick question are the billet thrust washers tight on the wrist pin ?

i have to push mine to get them on the pin ?