Suzuki Quadracer HQ

LT250R Quadracer => LT250R - Engine => Topic started by: LT250RWV on January 30, 2014, 10:34:55 pm

Title: Re: Throttle cable doesnt seem long enough.
Post by: LT250RWV on January 31, 2014, 10:12:49 am

Thanks for the help guys.

Title: Re: Throttle cable doesnt seem long enough.
Post by: Dezsled on January 31, 2014, 09:34:52 am

Terry cable makes a braided steel throttle cable that looks pretty sweet...

They can make custom cables. They can modify yours also if needed.

I sent motion pro my ltr450 throttle & cable , they gave me a twist throttle kit for the trouble. They said I had the first ltr450 they knew of! Thank you again Larry

Title: Re: Throttle cable doesnt seem long enough.
Post by: Iceracer on January 31, 2014, 07:29:14 am

Or Terry Cable also, if your +1 on the stem you want to get a custom cable.

Title: Re: Throttle cable doesnt seem long enough.
Post by: GrkGuy on January 31, 2014, 07:25:24 am

dont you have +1 steering stem to.

Title: Re: Throttle cable doesnt seem long enough.
Post by: Roach on January 31, 2014, 07:22:28 am

if not motion pro will make u one right up. i think it cost me 30ish shipped

Title: Re: Throttle cable doesnt seem long enough.
Post by: Iceracer on January 31, 2014, 07:13:40 am

Use your cable from the 39pwk, a zilla cable will be too short also without the OEM 500 Carb cap it is recessed and don't have the adjuster on the top.

Title: Re: Throttle cable doesnt seem long enough.
Post by: LT500Kid on January 31, 2014, 06:54:30 am

Check the way you routed the cable too. Sometimes that's makes a difference

Title: Re: Throttle cable doesnt seem long enough.
Post by: Nekrofilliak on January 31, 2014, 06:33:46 am

if I remember I had to remove the cable adjuster nut  on the thumb side , and adjust the free play on the carburator. maby that should help  ?

Title: Throttle cable doesnt seem long enough.
Post by: LT250RWV on January 30, 2014, 10:34:55 pm

I just put a new mikuni tm 38mm on my 91 lt250. When I put the cable in the slide it was tight. Twisted all the slack out of thumb throttle. Help a little.  Still to tight causing slide to lift. Got it down enough to control slide height. Put not enough slack in the cable. Anyone else have this problem. Should I order a zilla throttle cable. Would zilla cable fix this.