Suzuki Quadracer HQ

LT250R Quadracer => LT250R - Engine => Topic started by: Doug123 on January 24, 2014, 01:41:52 pm

Title: Re: Needle Removal
Post by: Doug123 on January 28, 2014, 06:34:30 am

That did it!  Thanks!

Title: Re: Needle Removal
Post by: Roach on January 25, 2014, 06:30:22 am

also the plate that holds the needle is slotted for the plastic piece to set in. its a little harder putting back in than taking out but after a few times its a piece of cake

Title: Re: Needle Removal
Post by: Roach on January 25, 2014, 06:27:52 am

pull the spring all the way up and hold with fingers. then tip slide upside down and it will slide out. then u can yake out the 2 screws. the spring is all that holds the plastic piece in

Title: Re: Needle Removal
Post by: Doug123 on January 25, 2014, 05:27:48 am

ok, thanks, but how do I get the plastic piece out that appears to be holding the throttle cable in place?

Title: Re: Needle Removal
Post by: Rainman56 on January 24, 2014, 03:51:24 pm

If I remember correctly should be 2 small screws down there once you get the throttle cable out.Take the screws out and the piece the cable hooks into and you should be able to slide the needle out.

Title: Re: Needle Removal
Post by: Doug123 on January 24, 2014, 02:08:47 pm

Yep, stock 1992 carb.

Title: Re: Needle Removal
Post by: Rainman56 on January 24, 2014, 01:44:59 pm

What carb?Stock TM?

Title: Needle Removal
Post by: Doug123 on January 24, 2014, 01:41:52 pm

Hi Guys - how do I remove the needle from the slide?  I'm trying to confirm the part # and clip position.  I've looked at it, but I'm not seeing how to do this.

Any help is appreciated.