Suzuki Quadracer HQ

LT250R Quadracer => LT250R - Exhaust => Topic started by: Protoolsuser81 on January 04, 2014, 06:16:17 pm

Title: Re: Exhaust valve rod fell off.
Post by: Protoolsuser81 on January 21, 2014, 11:29:31 am

Yea i'm just going to order a few of them.  Good call.

Title: Re: Exhaust valve rod fell off.
Post by: LT500Kid on January 20, 2014, 01:31:04 pm

Those clips break easily. Go to Suzuki dealer and get new ones. I bought 3 top ones and 3 bottom ones last time I needed them they are super cheap and if you break one next time you will have an extra one.

Title: Re: Exhaust valve rod fell off.
Post by: Protoolsuser81 on January 20, 2014, 12:05:23 pm

Well that little plastic bushing seems to not be holding that rod in very well as it fell out again. Any tricks to get this to stay in or should I just order a new bushing/plastic clip?

Title: Re: Exhaust valve rod fell off.
Post by: Protoolsuser81 on January 04, 2014, 07:35:32 pm

Nope, is that the dial on the opposite side of the engine?  Could you give me a quick walkthrough of what I should do?

Title: Re: Exhaust valve rod fell off.
Post by: PCS on January 04, 2014, 07:02:36 pm

did you try resetting the adjustment after you reconnected everything.

Title: Exhaust valve rod fell off.
Post by: Protoolsuser81 on January 04, 2014, 06:16:17 pm

I looked through the little glass window on my 90 lt250r and noticed the rod and white clip came out and was disconnected to the valve.  I took the little window section off and attached the rod. When I reved the engine a little I didn't see any movement. Is there a way to adjust this or some.steps I should take to sort this out?