Suzuki Quadracer HQ

LT250R Quadracer => LT250R - Body / Chassis / Suspension => Topic started by: LT250RWV on December 30, 2013, 08:20:03 pm

Title: Re: lt250r sprocket guard using one from ltz400
Post by: GrkGuy on January 04, 2014, 08:10:00 pm

looks good, now you need one for the rotor, cause if you bend it you are screwed..

Title: Re: lt250r sprocket guard using one from ltz400
Post by: LT250RWV on January 04, 2014, 02:48:43 pm

Pic on the quad

Title: Re: lt250r sprocket guard using one from ltz400
Post by: LT250RWV on December 31, 2013, 10:05:25 am

Yea gives us more of a option . (Y)

Title: Re: lt250r sprocket guard using one from ltz400
Post by: Dangerouspower on December 31, 2013, 08:25:51 am

Good to know ltz and lt are the same bolt pattern.

Title: Re: lt250r sprocket guard using one from ltz400
Post by: Dutch_Rutter on December 30, 2013, 11:48:35 pm

I like this idea, but I ave had a problem with a similar design on a 300ex the metal bent and had to be ripped off because the chain was basically cutting into it. but then again the kid riding it hit a stump and didnt tell anyone.. so probably wont have that problem... good thread though  P*

Title: Re: lt250r sprocket guard using one from ltz400
Post by: LT250RWV on December 30, 2013, 10:55:24 pm

That's just a mock up. I run alot smaller sprocket then the one in pic. I wasn't 100percent sure this would work. didn't have time to mess with quad tonight. So I grabbed extra stuff laying around. Also ltz400 sprockets work . Lots of those out their. But this a 42 tooth in pic. So I wouldn't do this if you have as big or bigger then it. 42 still might work will check.

Title: Re: lt250r sprocket guard using one from ltz400
Post by: GrkGuy on December 30, 2013, 08:49:33 pm

looks like you chain is gonna stick out past it still

Title: Re: lt250r sprocket guard using one from ltz400
Post by: LT250RWV on December 30, 2013, 08:36:04 pm

Another

Title: Re: lt250r sprocket guard using one from ltz400
Post by: LT250RWV on December 30, 2013, 08:32:58 pm

Another

Title: lt250r sprocket guard using one from ltz400
Post by: LT250RWV on December 30, 2013, 08:20:03 pm

Here is a couple pic of the sprocket guard. I wanted to use this to get more ground clearance. Will be on the quad tomorrow.