Suzuki Quadracer HQ

LT250R Quadracer => LT250R - Engine => Topic started by: Jsmitty42 on October 30, 2013, 12:20:49 pm

Title: Re: powervalve
Post by: LT250RWV on October 31, 2013, 06:18:53 am

If its the right washer from factory.  It doesnt have any magnetic properties.  So you will have to take clutch cover off or split the cases.

Title: Re: powervalve
Post by: GrkGuy on October 30, 2013, 06:23:26 pm

small magnet or take clutch cover off.
if you can put a magnet on a string that should get it out.

Title: Re: powervalve
Post by: Gillio on October 30, 2013, 02:41:09 pm

Flip the quad upside down and shake it. If that doesn't work try a magnet on the end of a piece of thick copper strand wire.

Title: Re: powervalve
Post by: Motoman991 on October 30, 2013, 01:20:53 pm

Take the clutch cover off.

Title: Re: powervalve
Post by: All American on October 30, 2013, 12:35:44 pm

It's titled broken power valve actuator.

Title: Re: powervalve
Post by: All American on October 30, 2013, 12:33:08 pm

There is a thread located next to last on this engine forum that talks about the power valves if you guys want any reference material. I don't know the answer to his question but I thought it may help ya.  Good luck with it.

Title: Re: powervalve
Post by: Chuckie25 on October 30, 2013, 12:27:28 pm

Bottom end as in by the clutch or by the crank?

Title: powervalve
Post by: Jsmitty42 on October 30, 2013, 12:20:49 pm

ok so i was taking the cylinder off and i took the powervalve bolt off and the washer went into bottem end -__- what do i have to do to get it out ? <1>