Suzuki Quadracer HQ
LT250R Quadracer => LT250R - General Discussion => Topic started by: Zilla273 on July 02, 2013, 02:40:05 pm
-
ive been noticing my 250 will misfire when revving, weird thing is it seems to pull through all the gears good, when I rev it with the clutch in it sounds like its got a limiter like a 4stroke 450. my jetting is 42 pilot,180 main with a pwk38.. shearer pipe, carls porting.. ive replaced the stator assembly and coil, this problem is hit or miss, sometimes it runs great does this sound like a cdi problem??
Most two strokes act rich at high RPM without a load on the engine. It might be a little rich but you are close to having the correct main jet if it pulls through the lower gears without a high RPM miss-fire.
If you install a main jet that runs clean at high RPM in neutral it will be too lean under a load.
-
check marks on stator to make sure they are lined up, or sounds like your jetting may be of
-
yeah I've tryed changing plug acpl times, it seems really flat up top too when its acting up
-
Our CR80 with a kart cylinder will do the same thing. Acts just like its on a rev limiter (sounds pretty badass lol)
Not the same thing I mean lol it doesn't misfire. Just acts like its on the limiter. I believe it's cause it's running out of fuel/air flow. Our 85 is RETARDEDLY ported though.
This may seem odd but have you tried replacing your plug?
-
yes it is a dgh needle
-
I believe its the dgh needle, il have to double check
-
What needle are you running in your 38pwk
-
biggest thing is when its doing it I cant launch, not even in 1rst gear in sand with 13 42gears :P
-
ive been noticing my 250 will misfire when revving, weird thing is it seems to pull through all the gears good, when I rev it with the clutch in it sounds like its got a limiter like a 4stroke 450. my jetting is 42 pilot,180 main with a pwk38.. shearer pipe, carls porting.. ive replaced the stator assembly and coil, this problem is hit or miss, sometimes it runs great does this sound like a cdi problem??