Suzuki Quadracer HQ

Suzuki Quadracer HQ Discussion => Suzuki Quadracer HQ - General Discussion => Topic started by: ZillaJoe on May 01, 2013, 03:20:40 pm

Title: Re: 96/97 kx 250 clutch problem
Post by: Maxxh2o on May 02, 2013, 08:02:43 am

Part #
13091 on the clutch microfiche

Title: Re: 96/97 kx 250 clutch problem
Post by: ZillaJoe on May 02, 2013, 04:45:37 am

Push rod holder? Arm on the flywheel side?

Title: Re: 96/97 kx 250 clutch problem
Post by: Maxxh2o on May 01, 2013, 04:36:35 pm

Is the clutch push rod holder in the right direction?  It is longer going one way versus the other.

Title: 96/97 kx 250 clutch problem
Post by: ZillaJoe on May 01, 2013, 03:20:40 pm

Ok I just rebuilt my bike new top end ,gaskets and clutch basket. Well after install  my clutch will not work at all all parts are there and in I lead and ended with fiber plates. Even tried a spacer between push rod and bearing. It acts like you stepped on the shifter in neutral but the clutch is pulled in. I rode the bike with a couple high revs and pulling the clutch every couple seconds to mabay looses clutch break up sticky plates nothing I adjusted both adjustments is there any special way to put the arm on fly wheel side.? Oh the clutch worked before rebuild it slipped a little bit because of a groves basket