Suzuki Quadracer HQ

LT500R Quadracer => LT500 - General Discussion => Topic started by: Mitch Keller on January 31, 2013, 11:17:20 am

Title: Re: Interest On Making OEM Type Front Bumpers
Post by: Stpltn250r on March 20, 2013, 04:06:59 pm

whatever happened to this is this still going to happen Mitch

Title: Re: Interest On Making OEM Type Front Bumpers
Post by: Dirtzilla on February 01, 2013, 05:28:08 pm

1987 is the skinny bumper  with the  curves at the ends.

Title: Re: Interest On Making OEM Type Front Bumpers
Post by: ZillaJoe on February 01, 2013, 10:15:34 am

Raw with teeth or just the bar  ranger? How wide Mitch ? Id say about 4 inches 2 inch on each side

Title: Re: Interest On Making OEM Type Front Bumpers
Post by: Rangercrt on February 01, 2013, 09:42:40 am

I would be up for a raw one.

Title: Re: Interest On Making OEM Type Front Bumpers
Post by: ZillaJoe on January 31, 2013, 09:45:38 pm

 fat bar  little wider on  top and a bar about as wide as the stock  oem top bar 6 inches below with teeth top and bottom  bars

Title: Re: Interest On Making OEM Type Front Bumpers
Post by: Mitch Keller on January 31, 2013, 06:30:56 pm

Quote from: FX4Pitrone on January 31, 2013, 06:02:55 pm

It's be cool if you could make them a little wider like the Pro-Armor bull horn bumper... more protection for front end that way too....

How much wider?  wide enough to protect the front shocks? You dont want anything solid in the middle that could block airflow to the radiator scoop.

Title: Re: Interest On Making OEM Type Front Bumpers
Post by: FX4Pitrone on January 31, 2013, 06:02:55 pm

It's be cool if you could make them a little wider like the Pro-Armor bull horn bumper... more protection for front end that way too....

Title: Re: Interest On Making OEM Type Front Bumpers
Post by: Mitch Keller on January 31, 2013, 12:15:25 pm

1990

Title: Re: Interest On Making OEM Type Front Bumpers
Post by: Stpltn250r on January 31, 2013, 12:10:11 pm

I would take a raw no light tabs.

What year is the fatbar? 1987?

Bumper on ebay for 87 with padding. 20 + 12 shipping

Title: Interest On Making OEM Type Front Bumpers
Post by: Mitch Keller on January 31, 2013, 11:17:20 am

I want another Fat Bar Front Bumper, and they want almost $70 bucks with shipping, not counting the plating cost, so I am looking into getting some bids on making 10 of these, also having a few sets made with light bar tabs to run laser star lights, getting quotes bare and plated.
Is there any modifications that members would like to see, other that going heavy wall thickness, OEM is too thin and dings easy.

My goal is to be sell them fro $85.00 plated /  $55.00 raw

OEM Front Bumper Plated
(http://i192.photobucket.com/albums/z183/erbe03/Suzukiquadracerhq/Streamlinefront-Copy_zpsb578c44a.jpg)