Rekluse clutches

• Rekluse clutches
  Posted by Chuckie25 on 13 Apr, 2014 14:54
• Anyone know if any of the Rekluse clutches will retro-fit to our Zukes? I see they have them for the RMZ250's but no clue if the clutches are even remotely close to ours,,,,   I figure the clutch cover itself will probably be the biggest limiting factor
• 
  
• #1 Reply
  Posted by Dwilkins126 on 13 Apr, 2014 15:33
• I'm going to go out on a limb and say no since our clutches are wet clutches unlike the RMZ-250. I would imagine if they were interchangeable it would be on their website or they would make one specifically for our bikes and other two strokes.
• 
  
• #2 Reply
  Posted by Dezsled on 13 Apr, 2014 16:06
• If your talking 2stroke they have them for the rm250.
  
  http://enduropilot.com/store/item/2dq3w/Rekluse_z-Start_PRO_Automatic_Clutches/SUZUKI_RM250_2-STROKE_06-08_Z-START_PRO_RMS863.html
• 
  
• #3 Reply
  Posted by Dwilkins126 on 13 Apr, 2014 16:15
• I didnt know they made them for a two stroke. Good to learn new things cause I am about to put one on my Z400 for my wife; she doesnt like the clutch.
• 
  
• #4 Reply
  Posted by Chuckie25 on 13 Apr, 2014 16:26
• almost all 2 stroke clutches are wet clutches,,, even the z400 is a wet clutch.....   
  
  But would it fit, Dez? I know they have a replacement outer clutch cover because the rekluse clutches are wider than the stock clutches so im thinking not unless someone were to make a 2-piece cover for the LT?
• 
  
• #5 Reply
  Posted by Dezsled on 13 Apr, 2014 16:31
• Good question chuckie...
  
  DW that's not a cheap mod but no stalling would be sweet those learning
• 
  
• #6 Reply
  Posted by Mercenary223 on 13 Apr, 2014 23:38
• If the rm uses the same clutch basket then it can be made to work.  I just bought a crf450r z-start pro and had to get a different spacer that goes above the clutch lifter and a different gasket for my clutch cover because the rekluse sticks out slightly more then stock.   This was a great upgrade for me in the slow single track I ride. 
  
  I am sure rekluse doesnt make parts for the lt but if you could figure out the size of the spacer I am sure they would have them it is basically just a different sized washer.  Also if space was a issue you could make your own thicker clutch cover gasket.
•