Ok I just rebuilt my bike new top end ,gaskets and clutch basket. Well after install my clutch will not work at all all parts are there and in I lead and ended with fiber plates. Even tried a spacer between push rod and bearing. It acts like you stepped on the shifter in neutral but the clutch is pulled in. I rode the bike with a couple high revs and pulling the clutch every couple seconds to mabay looses clutch break up sticky plates nothing I adjusted both adjustments is there any special way to put the arm on fly wheel side.? Oh the clutch worked before rebuild it slipped a little bit because of a groves basket
Is the clutch push rod holder in the right direction? It is longer going one way versus the other.
Push rod holder? Arm on the flywheel side?
Part #
13091 on the clutch microfiche