could you fit a ktm360 in the lt?

• could you fit a ktm360 in the lt?
  Posted by Golden250r on 02 May, 2013 20:17
• is it possible to fit a ktm 360 in the lt 85/ 86 frame? will no major crazy mod i don't care about exhaust work or small welds to using different engine mount plates
• 
  
• #1 Reply
  Posted by Iceracer on 03 May, 2013 03:36
• It should be very similar to a hybrid 500 mod.
• 
  
• #2 Reply
  Posted by JayTater on 03 May, 2013 10:26
• THAT would be an excellent build!!!!!! I've been wanting to do a Husky WR brid, just haven't had the cash to get thecomponents needed to make it happen. DO IT!!!
• 
  
• #3 Reply
  Posted by PCS on 03 May, 2013 13:38
• if you have the motor just put it next to the lt motor and look at them side by side, should give you and idea about the mounting the ktm motor inside the lt frame.
• 
  
• #4 Reply
  Posted by Golden250r on 03 May, 2013 14:00
• Quote from: PCS on 03 May, 2013 13:38

  if you have the motor just put it next to the lt motor and look at them side by side, should give you and idea about the mounting the ktm motor inside the lt frame.
  

  =) i found a bike for 800 obo so wondering if it was feasible
• 
  
• #5 Reply
  Posted by PCS on 06 May, 2013 22:17
• good luck on the swap!
• 
  
• #6 Reply
  Posted by GrkGuy on 07 May, 2013 09:00
• i think the main thing you need to worry about is, carb location with filter and sprockets lining up. oh and the pipe
  is the axle bolt same size also
• 
  
• #7 Reply
  Posted by JayTater on 15 Jun, 2013 11:50
• Anything come of this Josh?
• 
  
• #8 Reply
  Posted by WestTexasKing on 15 Jun, 2013 12:51
• If you're going with an off the wall single, why not go with a Maico 620 instead?
•